Introduction

This section will help you to configure your MyGo Mini. There are 2 main ways you can connect to your MyGo Mini.

LAN Connection

You can connect to your MyGo Mini over a local area network using the ethernet cable provided. Please ensure that the socket you are connected to is the network you will be using on your desired computer. If the LAN is connected to your WIFI it is also possible to connect to the instrument over WIFI.

USB Connection

An experiment protocol can be saved on the USB stick provided and plugged into the MyGo Mini. The INstrument will automatically run the experiment. Once complete you can remove the USB stick and analyse the results.

Connecting to your Instrument

Please open up the MyGo Mini software and select Configuration button at the top right of your screen as shown below:

image alt text

The configuration window should be the same as shown below:

image alt text

Please select the MyGo Mini tab on the left as shown below:

image alt text

To add your new MyGo Mini select the Add button at the bottom of the screen. You will now be presented with a list of available instruments to connect to.

image alt text

Double click on the instrument you wish to connect to or press select with the instrument selected. The instrument will now be added to the list of Registered Instruments for use in the software.